@gwfami wrote:
I installed the latest version of bitmap to mesh via the sketchup extensions store, verified that it had been installed and enabled and that the latest version of TT_Lib2 is installed and enabled.
When clicking draw/mesh from heightmap, I get a select image window, I select the dem02_original_100.bmp, select the plane, image loads, then select the height. At this point an error box appears and I am stuck in select the height and have to restart sketchup (error shown below). I am also unable to get my bitmaps to load, just get the same error box as before, with no hangups. Any ideas?
Wasn’t sure where to put @thomthom to get his attention, so put it both here and in the title.
Posts: 3
Participants: 3