Hello.
Sorry I have fighting this all afternoon and am drawing a bit of a blank here.
I am creating kitchen cabinets, and its a pretty straight forward design I think. When I generate the cutlist it says on a lot of them that size is not defined.
I have only two materials, one is 18mm and one is 9mm
I can see a few errors with the 9 because my material is actual 10mm but so far as I can tell all of my 18mm are 18mm deep. It says the 18m us rounded by the precision of the model and really its 18.03 or something. but when I run rulers on the piece it says 18mm
I think because of this its splitting up the parts list which then means I cannot run the cutting diagramme properly as I have lots of space left over.
Anyway, any hints, or resources. I watched the Youtube embedded in the help bit, but that was based on a perfect model which evidently I don’t have
2 posts - 2 participants