Hey guys, I am new to SketchUp and having issues creating fencing assemblies in Profile Builder 3.
When creating a fence with the assembly I have created, the profile members (top & bottom rails) extrude through the posts between the Start and End posts. This leads to unwanted geometry within some of the posts. This also throughs out the spacing of my infills (12mm bars) as the measurement for their spacing is not being taken from between the posts as I would like, but rather along the whole length of the profile members themselves.
I would like to use the assembly builder to model a scaled fence and use the Open Cut lists extension to generate a cut-list for the individual components. But due to the profile members being extruded as long continuous pieces, rather than individual sections between the posts, it throughs off the generation of the cut list.
Hope this makes sense. Any hints of tips would be gratefully received. Thanks.
Assembly Issue.skp (456.3 KB)
1 post - 1 participant