Hello all, I am having some trouble with the extension roundcorner. I’m trying to round the edges of a skin I made with the extension soap skin and bubble, and I’m running into a lot of overlapping pieces that get completely screwed up after rounding. Roundover wont let me round a component or group (is this normal?) and when I explode the group and highlight each individual section of the curve I run into the overlapping issue. There are two skins that meet at the
curved edge, is this the problem? I am able to round over the front edges to 1/8" not including the skins fine, then when I go to round the rear edges at 3/8", the rear face disappears…
It also looks like the skins made with soap bubble are not even connected to the rest of the model after rounding the edges. I’m lost
Thanks in advance!
OP04 copy.skp (2.1 MB)
9 posts - 4 participants