@SDhatter wrote:
Hi, I’m new to this so probably just haven’t found the answer to the problem on this forum. Anyway, I’ve tried using Fredo Scale to create rose petals from a traced jpeg. As soon as I try to bend the newly made component of the petal, it creates breaks/ holes in the face of the component. I have seen the tutorials for making a rose created from a cut section of a globe using Fredo Scale, which seemed to work ok in the tutorial but when I tried to replicate it, even the globe section lost the original face and had holes appear in the surface after using the extension. I’ve tried to correct this manually by re-drawing the lines and then hiding or softening them to lose the visible amendments. Any clues what I’m doing wrong or is this a common problem?
Posts: 10
Participants: 3
